![]() ![]() Packet Tracer crashes when configuring DHCP on WLC-PT wireless controller. The issue has been identified by Cisco and it's correction has been integrated in Packet Tracer 7.1.1 When configuring the WLC port to trunk mode and applying a static IP to the WLC, connection to the management interface of the WLC fails. detailed data is not available as this function has not been implemented in Packet Tracer 7.1 The WLC displays thesuccessfully registered Access Points with thir IP address. Lightweight Access Points automatically discover the WLC address using DHCP option 150 configured on the DHCP which has been configured on the Catalyst switch for Vlan 1. Interface Admin Oper Power Device Class Maxįa0/1 auto on 5.0 Light Weight Access Point0n/a 15.4įa0/2 auto on 5.0 Light Weight Access Point1n/a 15.4įa0/3 auto on 5.0 Light Weight Access Point2n/a 15.4 Attention is required for the access switch deployment which needs reduncdant power supplies and suffisant power budget from the closet to power up all the connected WLC. LightWeight Access Points automatic registrationĬisco Lightweight access points are directly connected to the layer 3 Catalyst 3560 switch and are PoE power supplied by the switch, making deployment quite easy. Packet Tracer 8.2 supports the following security options : Each WLAN SSID is associated to a VLAN previously created and linked to a pysical interface on Controller tab. WLAN creation and SSID to VLAN mapping is configured on the WLAN tab of the WLC configuration. If you try to connect using HTTP (unsecure) the WLC resets the connection but doesn't automatically redirect the connection to the HTTPS url. Īfter this initial setup, reconnect to the Cisco WLC using HTTPS (). Please note that the Guest Network function is not supported in Packet Tracer 8.2. ![]() The second step is to configure time, location, and management IP address of the WLC before creating the first protected Wireless network. Packet Tracer 7.1 issue : Access to the web interface can fail several times before allowing showing the following page. Make sure to connect using HTTP (unsecure), not HTTPS, for this first connection. The admin credentials will be login: admin, password : in this tutorial. Connect to the WLC 2504 using the web browser of the management laptop using and configure the admin username and password.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |